Hybrid inverter · Hiconics Eco-energy Drive Technology · CEC approved September 2026
CEC listing: MEI2-HT29.9H-AU (AS4777-2 2020)
A 29.9 kW three-phase hybrid inverter that is battery-ready.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Not on file: we don’t have this figure from the manufacturer’s documents yet, so we leave it blank rather than print a typical value. Ask your installer to confirm it on the quote. Seen it in a document? Tell us
Every figure on file for the Hiconics Eco-energy Drive Technology MEI2-HT29.9H-AU, by section.
| Specification | Value |
|---|---|
| DC input & MPPT | |
| MPPT trackers | 3 |
| Physical | |
| IP rating | IP66 |
| Installation requirements | |
| Top clearance | 500 mm |
| Side clearance | 200 mm |
| AC breaker | 40 A |
| Cable gauge | 10 mm² |
| Earthing method | TN-S |
| DNSP pre-approval | Yes |
| Estimated install time | 5 hrs |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
The Hiconics Eco-energy Drive Technology MEI2-HT29.9H-AU against the closest-power inverters from other brands.
| Specification | Hiconics Eco-energy Drive Technology MEI2-HT29.9H-AUHiconics Eco-energy Drive Technology | Solplanet ASW29.9K-THSolplanet | Solplanet ASW30K-LT-G3Solplanet |
|---|---|---|---|
| Rated power? | 29.9 kW | 29.9 kW | 29.9 kW |
| Max efficiency? | Not on file | Not on file | Not on file |
| MPPT trackers? | 3 | Not on file | Not on file |
| Phases | Three-phase | Three-phase | Three-phase |
| Type | Hybrid | Hybrid | Solar |
| Battery ready | Yes | Yes | No |
| Warranty | 10 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
This warranty covers defects for 10 years. It excludes damage from improper installation. Claims can be made through customer support.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 15 of 15. The official install manual is the authoritative source — always confirm before acting.
01warningLine voltage high loss
02warningLine voltage low loss
03warningLine frequency high loss
04warningLine frequency low loss
05warningLine voltage loss for long time
07warningIsland detect
08warningLine waveform loss
09warningCall your installerLine phase loss
10warningEPO detected
11warningOverload
12warningOver temperature
13warningBattery voltage low
14warningCall your installerBattery under-voltage when grid is lost
15warningCall your installerBattery open
16warningBattery under-voltage when grid is OK
MH-HYIV29.9-TH-AU (AS4777-2 2020)
29.9 kW · 3φ
MEI2-HT30H-AU (AS4777-2 2020)
30 kW · 3φ
MH-HYIV30.0-TH-AU (AS4777-2 2020)
30 kW · 3φ
MEI2-HT25H-AU (AS4777-2 2020)
25 kW · 3φ
MH-HYIV25.0-TH-AU (AS4777-2 2020)
25 kW · 3φ
MEI2-HT20H-AU (AS4777-2 2020)
20 kW · 3φ
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.