Battery inverter · FoxESS · CEC approved June 2025
CEC listing: KA8 (AS4777-2 2020)
An 8 kW single-phase battery inverter that is listed for battery storage on Synergy's list.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Not on file: we don’t have this figure from the manufacturer’s documents yet, so we leave it blank rather than print a typical value. Ask your installer to confirm it on the quote. Seen it in a document? Tell us
Every figure on file for the FoxESS KA8, by section.
| Specification | Value |
|---|---|
| Physical | |
| IP rating | IP65 |
| Rebate eligibility | |
| Listed for battery storage on Synergy's list | Yes |
| Installation requirements | |
| Top clearance | 500 mm |
| Side clearance | 500 mm |
| AC breaker | 63 A |
| Cable gauge | 10 mm² |
| Earthing method | TN-S |
| DNSP pre-approval | No |
| Estimated install time | 8 hrs |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Listed for battery storage on Synergy's list. Synergy's Supported Solutions List covers inverters approved for control. A battery system needs an inverter with a battery-storage (DER-Storage) listing on this list to be eligible for the WA Battery Scheme. A listing for generation only doesn't count. Other scheme conditions apply.Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Estimate for a full-size array on this inverter
At 5 peak sun hours a day (BOM) with a 15% system derate.
Australian office
Has local presence
Website
au.fox-ess.comThe FoxESS KA8 against the closest-power inverters from other brands.
| Specification | FoxESS KA8FoxESS | Energizer Force 8.0HS+Energizer | Energizer Force 8.0HT+Energizer |
|---|---|---|---|
| Rated power? | 8 kW | 8 kW | 8 kW |
| Max efficiency? | Not on file | Not on file | Not on file |
| MPPT trackers? | Not on file | Not on file | Not on file |
| Phases | Single-phase | Single-phase | Three-phase |
| Type | Battery | Hybrid | Hybrid |
| Battery ready | Yes | Yes | Yes |
| Warranty | 10 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
The warranty covers parts for 10 years. It excludes damages from improper installation. To claim, contact customer support.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 19 of 19. The official install manual is the authoritative source — always confirm before acting.
Ground FaultcriticalCall your installerThe ground connection is failed.
Iso FaultcriticalCall your installerThe isolation is failed.
Res Cur FaultcriticalCall your installerThe residual current is high.
10min Volt FaultwarningThe grid voltage is out of range for the last 10 minutes.
Bat Power LowwarningThe battery power is low.
Bat Volt FaultwarningBattery voltage fault.
DCI FaultwarningDC component is out of limit in output current.
Eps Over LoadwarningOver load in off-grid mode.
Grid Freq FaultwarningGrid frequency out of range.
Grid Lost FaultwarningGrid is lost.
Grid Volt FaultwarningGrid voltage out of range.
HW Inv Cur FaultwarningOutput current high detected by hardware.
Over Load FaultwarningOver load in on-grid mode.
Pv Volt FaultwarningPV voltage out of range.
SW Bat Cur FaultwarningBattery current high detected by software.
SW Bus Vol FaultwarningBus voltage out of range detected by software.
SW Inv Cur FaultwarningOutput current high detected by software.
SW Pv Cur FaultwarningPV input current high detected by software.
Temp FaultwarningThe inverter temperature is high.
1K5-1P-HI-8 (AS4777-2 2020)
8 kW · 1φ
G8 (AS4777-2 2020)
8 kW · 1φ
G8 (AS4777-2 2020)
8 kW · 1φ
KH8 (AS4777-2 2020)
8 kW · 1φ
PQ1-8.0_EQ5500-S_2S (AS4777-2 2020)
8 kW · 1φ
PQ1-8.0_EQ5500-S_3S (AS4777-2 2020)
8 kW · 1φ
Other CEC-approved products from FoxESS available in Australia.
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.