Solar inverter · FoxESS · CEC approved October 2025
CEC listing: G8 (AS4777-2 2020)
An 8 kW single-phase solar inverter that is listed for battery storage on Synergy's list.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Not on file: we don’t have this figure from the manufacturer’s documents yet, so we leave it blank rather than print a typical value. Ask your installer to confirm it on the quote. Seen it in a document? Tell us
Every figure on file for the FoxESS G8, by section.
| Specification | Value |
|---|---|
| Rebate eligibility | |
| Listed for battery storage on Synergy's list | Yes |
| Installation requirements | |
| Top clearance | 300 mm |
| Side clearance | 300 mm |
| AC breaker | 50 A |
| Cable gauge | 10 mm² |
| Earthing method | TN-S |
| DNSP pre-approval | No |
| Estimated install time | 14 hrs |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Listed for battery storage on Synergy's list. Synergy's Supported Solutions List covers inverters approved for control. A battery system needs an inverter with a battery-storage (DER-Storage) listing on this list to be eligible for the WA Battery Scheme. A listing for generation only doesn't count. Other scheme conditions apply.Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Estimate for a full-size array on this inverter
At 5 peak sun hours a day (BOM) with a 15% system derate.
Australian office
Has local presence
Website
au.fox-ess.comThe FoxESS G8 against the closest-power inverters from other brands.
| Specification | FoxESS G8FoxESS | Energizer Force 8.0HS+Energizer | Energizer Force 8.0HT+Energizer |
|---|---|---|---|
| Rated power? | 8 kW | 8 kW | 8 kW |
| Max efficiency? | Not on file | Not on file | Not on file |
| MPPT trackers? | Not on file | Not on file | Not on file |
| Phases | Single-phase | Single-phase | Three-phase |
| Type | Solar | Hybrid | Hybrid |
| Battery ready | No | Yes | Yes |
| Warranty | 10 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
This warranty covers EQ series products for 10 years, excluding improper installations and environmental conditions. Claims must be made within 3 months of the last online connection.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 22 of 22. The official install manual is the authoritative source — always confirm before acting.
Bus OVPcriticalCall your installerBus over voltage
Comm LostcriticalCall your installerCommunication lost
Consistent FaultcriticalCall your installerConsistent fault detected
DCI FaultcriticalCall your installerDC interface fault
EEPROM FaultcriticalCall your installerEEPROM fault detected
GFC FaultcriticalCall your installerGround fault detected
GFCD FaultcriticalCall your installerGround fault circuit detection fault
Grid 10Min OVPcriticalCall your installerGrid over voltage
Ground FaultcriticalCall your installerGround fault detected
Isolation FaultcriticalCall your installerIsolation fault detected (Australia market only)
MS Comm LostcriticalCall your installerMaster communication lost
OCPcriticalCall your installerOver current protection activated
Over TempcriticalCall your installerOver temperature fault
PLL FaultcriticalCall your installerPhase locked loop fault
Relay FailcriticalCall your installerRelay failure detected
Sample FaultcriticalCall your installerSampling fault detected
Grid Freq FaultwarningCall your installerGrid frequency fault
Grid Lost FaultwarningCall your installerLost connection to the grid
Grid Voltage FaultwarningCall your installerGrid voltage fault
PV OVPwarningCall your installerPV open voltage over limit
SPS FaultwarningCall your installerSPS fault detected
VGridTransient FaultwarningCall your installerTransient grid voltage fault
1K5-1P-HI-8 (AS4777-2 2020)
8 kW · 1φ
G8 (AS4777-2 2020)
8 kW · 1φ
KA8 (AS4777-2 2020)
8 kW · 1φ
KH8 (AS4777-2 2020)
8 kW · 1φ
PQ1-8.0_EQ5500-S_2S (AS4777-2 2020)
8 kW · 1φ
PQ1-8.0_EQ5500-S_3S (AS4777-2 2020)
8 kW · 1φ
Other CEC-approved products from FoxESS available in Australia.
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.