Batteries11 listed
- Approved models
- 10
- Usable capacity
- 13.5-40.5 kWh
- Warranty
- 10 years · terms listed for 1 of 11 models
- Chemistry
- LFP
- Backup capable
- 1 of 11 models
Tesla · manufacturer profile
The Powerwall 3 and its Expansion units
Solar manufacturer
Updated 3 November 2026 · Checked against Tesla's Australian warranty and datasheets, the CEC register (16 November 2026) and Synergy's list (30 October 2026) · By Solar Battery Perth
In short
Tesla's home battery for Australia is the Powerwall 3, a 13.5 kWh unit with the solar inverter built in. Up to three Expansion units stack behind it, each adding 13.5 kWh, and a home can run up to four Powerwall 3s. In a blackout it backs up the whole home or part of it through a Backup Gateway 2. The warranty runs 10 years and promises 70% of 13.5 kWh, with no cycle limit for everyday solar use. Its inverter is built in and cannot be swapped. A battery system needs an inverter with a battery-storage (DER-Storage) listing on Synergy's Supported Solutions List to be eligible for the WA Battery Scheme. Other scheme conditions apply. Powerwall 3 is not eligible for the WA Battery Scheme. Its inverter is built in, and the Powerwall 3 is not approved for battery storage on Synergy's list, so no inverter pairing can make it qualify.
Specifications and pricing change. Confirm them with the manufacturer.
The company
No Tesla document we read describes the company itself. So this page sticks to the Australian warranty and the datasheets. Tesla Motors Netherlands B.V. gives the warranty. It covers a Powerwall bought from Tesla or a Tesla certified installer in Australia or New Zealand, and installed there.
A claim goes first to the Tesla certified installer who sold the Powerwall. After that it goes to Tesla's Powerwall warranty claims address in Alexandria, New South Wales, or to the Powerwall support email for Australia and New Zealand.
From the Powerwall Warranty (Australia and New Zealand), Rev. 1.17, read 8 October 2026.
The solar inverter is inside the battery. A Powerwall 3 takes up to 20 kW of panels straight in on three MPPTs (the trackers that get the most out of each string of panels). So a new solar-and-battery install is one unit on the wall. Its output comes in three sizes set by the model code: 5, 10 or 11.04 kW. The 3AC version has no solar input.
The other difference is how it grows. Expansion units add storage without more inverter. Each holds 13.5 kWh, and up to three stack behind one Powerwall 3 on the floor. A home that needs more output adds a second Powerwall 3, up to four. The warranty counts cycles differently too: no limit for everyday solar use, with an energy cap only for other uses.
Two Powerwall 3 versions and the Expansion unit are on the Clean Energy Council (CEC) register, which records the cells as LFP (lithium iron phosphate). No Tesla datasheet we read names the cell chemistry. Every Tesla listing we checked runs into late 2027. The full model code carries the output size and the number of Expansion units, and a quote should show it.
13.5 kWh usable, solar inverter built in, 5, 10 or 11.04 kW, IP67 battery, secured with its wall bracket at all times, 130 kg
CEC approved
13.5 kWh usable, 5 kW, no solar input
CEC approved
13.5 kWh, no inverter, stacks behind a Powerwall 3 on the floor, 110 kg
CEC approved
The switch that cuts the grid off and runs the home from the battery in a blackout
Listed with each Powerwall 3
It stores 13.5 kWh usable, 14 kWh in total, measured new at 25 °C. The solar inverter inside takes up to 20 kW of panels on three MPPTs, with a panel input of 60 to 550 volts. Output is 5, 10 or 11.04 kW depending on the model code. Charging is held at 5 kW for now: the datasheet prints 8 kW with Expansions but limits it to 5 kW until a future firmware version.
In a blackout the Backup Gateway 2 detects the outage, disconnects the home from the grid and runs it from the battery. Whole-home and partial-home backup are both supported. For motor loads the datasheet rates it at 185 locked rotor amps, the surge a pump or air conditioner draws as it starts.
Efficiency is 89% from solar to battery to home, measured new at 25 °C, and 97.5% from solar straight to the home. It works from -20 °C to 50 °C and may cut its output above 40 °C. The battery and electronics are rated IP67, sealed against dust and immersion, and the enclosure IP55, so it goes outside or in. It measures 1105 by 609 by 193 mm with the glass cover and weighs 130 kg. Tesla's Australian install manual says it must be mounted with the wall bracket at all times, and that stacked Expansion units must be ground mounted.
The Expansion unit adds 13.5 kWh behind a Powerwall 3, up to three deep on the floor, and it only works with a Powerwall 3. It is rated IP67 and weighs 110 kg. The 3AC has the same 13.5 kWh and a 5 kW output, with no solar input.
Tesla's datasheets say yes, two ways. The 3AC is built for it. It has no solar input of its own, so the existing solar inverter stays and the battery meets it on the household side. In WA, adding a battery to an existing solar system counts as an alteration and can trigger whole-of-site compliance, so compare an AC-coupled retrofit against replacing your inverter with a hybrid. For many existing systems the sound path is replacing toward a DC-coupled / hybrid-inverter setup rather than expanding an AC-coupled one, avoiding future compliance limitations. The same datasheet says the standard Powerwall 3 supports both AC and DC coupled set-ups as well. No Tesla document we read names which other makers' inverters that covers. So the installer confirms the existing inverter in writing. Our inverter compatibility guide covers what AC coupling involves in WA.
The register records LFP cells for every Powerwall 3 listing. The battery and its electronics are sealed to IP67. No Tesla datasheet we read prints a cell chemistry. The datasheets list IEC 62619 and UL 1973 among their certifications, and say the Powerwall 3 meets the unit-level performance criteria of the UL 9540A fire test.
Ten years from the installation date, against defects, for a Powerwall bought from Tesla or a Tesla certified installer in Australia or New Zealand. The 3AC's datasheet prints the same 10 years; the warranty names it by part number pattern rather than by name.
The capacity promise is 70% of 13.5 kWh at 10 years, which is about 9.45 kWh. For solar self-consumption, time-based control and backup the cycles are unlimited. For any other use, or a mix that includes one, the promise instead ends once 37.8 MWh (37,800 kWh) has passed through the battery's output.
Two conditions matter most. The Powerwall has to be registered and kept connected to the internet. If it is offline for an extended period or never registered, Tesla may honour four years instead of ten. The warranty also excludes a unit not operated or maintained to the owner's manual. It sets no temperature or siting condition of its own.
A claim goes first to the Tesla certified installer who sold the system, then to Tesla's Powerwall warranty claims address in Alexandria, New South Wales. The warranty carries the Australian Consumer Law guarantee statement.
The warranty answer is 10 years at 70% of 13.5 kWh, with no cycle limit for everyday solar use. No Tesla datasheet we read prints a rated cycle life or a yearly loss figure. So the warranty is the only lifespan figure we have.
Showing: Western Australia, Synergy network. Other states: not covered yet
A battery system needs an inverter with a battery-storage (DER-Storage) listing on Synergy's Supported Solutions List to be eligible for the WA Battery Scheme. Other scheme conditions apply. Powerwall 3 is not eligible for the WA Battery Scheme. Its inverter is built in, and the Powerwall 3 is not approved for battery storage on Synergy's list, so no inverter pairing can make it qualify.
Synergy's list dated 30 October 2026 carries the Powerwall 3 with Backup Gateway 2, but without the DER storage flag and without the WA Residential Battery Scheme flag. DER means distributed energy resources, the list's term for a battery it can control. The list names inverters, and the Powerwall 3's inverter is built in, so there is no separate inverter to swap for a listed one.
Synergy's own VPP is Battery Rewards. A VPP (virtual power plant) is a program that lets a retailer draw on home batteries, and Battery Rewards starts from the same DER storage listing. The federal Cheaper Home Batteries program is a separate scheme with its own rules. The installer's quote shows what applies.
If you are comparing the Powerwall 3 with other batteries, the rest of the scheme's rules are in our WA battery rebate guide. Our guide to Synergy's approved products explains the list and its flags.
The Powerwall 3 is one unit: 13.5 kWh, the solar inverter and the backup switching through its gateway. It is secured with its wall bracket at all times, outdoors or in a garage. Tesla's manual says it is not intended for a living space and advises against direct sun. Storage grows with Expansion units, and output grows with a second Powerwall 3. Two facts decide fit in WA: the internet condition on the warranty, and the rebate. A battery system needs an inverter with a battery-storage (DER-Storage) listing on Synergy's Supported Solutions List to be eligible for the WA Battery Scheme. Other scheme conditions apply. Powerwall 3 is not eligible for the WA Battery Scheme. Its inverter is built in, and the Powerwall 3 is not approved for battery storage on Synergy's list, so no inverter pairing can make it qualify.
Ask the installer for the full model code, which carries the output size and the number of Expansions. Ask how the gateway is wired for backup and which circuits it covers. The installer's quote sets the price. The model code, the Expansion count and the gateway on it are the parts to check against this page.
Solar Battery Perth is independent. We're not owned by an energy retailer or a manufacturer. Installers quote the actual price.
For checking
| Warranty | 10 years on the Powerwall 3, if it stays registered and onlineTesla's Powerwall Warranty (Australia and New Zealand) |
|---|---|
| Batteries | LFP (lithium iron phosphate), 13.5-40.5 kWh usable |
| Approved now | 10 batteries and 19 inverters on the CEC (Clean Energy Council) register |
| Support in Australia | Office. Contact details |
| Local support | Yes, support handled through Australian channelsSource: maker's Australian site, checked 8 May 2026Confirmed |
| CEC listings | 29 approved right now · 2 delistedApproved |
| Documents |
Each product type at a glance. The full lists, grouped by series, are below.
Pick a type to open its full list, grouped by series.
Grouped by series. Open a series for each variant, or a model for full specs.
10 CEC-approved batteries, 1 not currently listed · grouped into 4 series
The CEC lists each size of this product, paired with each inverter, as its own approval. Pick a size to see its full specs.
CEC model: 1707000-10 kVA-13.5 (AS4777-2 2020) · LFP
View seriesGrouped by series. Open a series for each variant, or a model for full specs.
19 CEC-approved inverters, 1 not currently listed · grouped into 2 series
Compatible batteries: Powerwall 3 13.5kWh
| Battery Model | Powerwall 3 13.5kWh |
|---|---|
| Charge/Discharge (kW) | 5/11.04 |
Understanding Power Ratings:
* DC charge/discharge power varies from AC power due to inverter efficiency. Always consult with your installer for specific system design.
What has happened to Tesla on the CEC register.
Each block is one register event. Tap a year to see its events in the list below.
Powerwall 1 Announced
Tesla announces first home battery product globally
ACCC recall: Powerwall 2
Most affected units have already been remotely discharged by Tesla. While the risk of overheating is now very low, if it does occur, it may lead to a fire that could cause serious injury, death or damage to property. A few incidents have occurred and caused damage to property. No injuries have been reported.
⚡ 20 Inverter Models Listed
Inverter range expanded to 20 CEC-approved models.
ACCC recall update: Powerwall 2
Status: still active
Powerwall 3 is not eligible for the WA Battery Scheme. Its inverter is built in, and the Powerwall 3 is not approved for battery storage on Synergy's list, so no inverter pairing can make it qualify. The federal Cheaper Home Batteries program is a separate scheme with its own rules.
Yes. Up to three Expansion units stack behind one Powerwall 3, each adding 13.5 kWh, and they only work with a Powerwall 3. For more output, a home adds a second Powerwall 3, up to four in one system.
The warranty ends. It promises 70% of 13.5 kWh at the ten-year mark, about 9.45 kWh. No Tesla document we read says what to expect after that. No datasheet prints a yearly loss figure either.
The Tesla certified installer who sold the system, first. After that, Tesla's Powerwall warranty claims address in Alexandria, New South Wales, or the Powerwall support email for Australia and New Zealand, both in the Support in Australia section above.
Yes. The battery and electronics are rated IP67 and the enclosure IP55, and the datasheet rates it for indoor and outdoor use. It works from -20 °C to 50 °C and may cut its output above 40 °C. Tesla's installation manual does not recommend direct sunlight for the Powerwall or the gateway, so a shaded wall is the better spot. It also says to install Powerwall in a location that prevents damage from flooding, and cautions against water sources above or near the unit.
Tesla's home batteries use LFP (Powerwall 3) cells. LFP (lithium iron phosphate) is the most common residential chemistry in WA for its long cycle life and stability in Perth's heat.
Solar Battery Perth lists 10 CEC-approved Tesla battery models with specs, indicative pricing and warranty detail. Compare them against other brands to find the best fit for your Perth home.
Tesla has 19 CEC-approved inverter models from 5-11 kW (single phase). Compare them against other brands by size, phase and battery compatibility.
Are you Tesla?
Help us keep this profile up to date.
How the WA Battery Scheme works, and why eligibility follows the inverter on the quote.
What Synergy's Supported Solutions List covers, and how our inverter library shows which models are on it.
How the inverter paired with a battery sets its charge rate, discharge rate and backup power.
Who to contact first when a home battery fails, and what records to keep.
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
Product specifications, pricing, and availability are subject to change without notice. We make no warranties regarding product performance, longevity, or suitability for your specific needs.
Always verify specifications with the manufacturer and installer before purchase. Warranty terms are set by manufacturers and may have conditions not disclosed here. Battery performance degrades over time.