Loading Solar Battery Perth...
Loading Solar Battery Perth...
Hybrid inverter · Shenzhen Sinexcel Isuna Energy Technology · CEC approved October 2026
CEC listing: Isuna D10K-SL-AU (AS4777-2 2020)
A 10 kW single-phase hybrid inverter that is battery-ready.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Not on file: we don’t have this figure from the manufacturer’s documents yet, so we leave it blank rather than print a typical value. Ask your installer to confirm it on the quote. Seen it in a document? Tell us
Every figure on file for the Shenzhen Sinexcel Isuna Energy Technology Isuna D10K-SL-AU, by section.
| Specification | Value |
|---|---|
| Physical | |
| IP rating | IP65 |
| Installation requirements | |
| Top clearance | 1200 mm |
| Side clearance | 300 mm |
| AC breaker | 125 A |
| Cable gauge | 6 mm² |
| Earthing method | Non-grounded PV array, PE to earth ground |
| DNSP pre-approval | No |
| Estimated install time | 3 hrs |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Estimated installed, inverter only
$3,500–$6,000
Estimate, modelled from its size, Feb 2026 ratesPrices vary by installer, configuration and site complexity. Get exact quotes from installers you choose.
Compare quotes from installers you choose
Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Estimate for a full-size array on this inverter
At 5 peak sun hours a day (BOM) with a 15% system derate.
The Shenzhen Sinexcel Isuna Energy Technology Isuna D10K-SL-AU against the closest-power inverters from other brands.
| Specification | Shenzhen Sinexcel Isuna Energy Technology Isuna D10K-SL-AUShenzhen Sinexcel Isuna Energy Technology | Energizer Force 10.0HS+Energizer | Energizer Force 10.0HT+Energizer |
|---|---|---|---|
| Rated power? | 10 kW | 10 kW | 10 kW |
| Max efficiency? | Not on file | Not on file | Not on file |
| MPPT trackers? | Not on file | Not on file | Not on file |
| Phases | Single-phase | Single-phase | Three-phase |
| Type | Hybrid | Hybrid | Hybrid |
| Battery ready | Yes | Yes | Yes |
| Warranty | 5 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
Sinexcel Isuna offers a 5-year limited warranty on inverters, covering defects not caused by improper installation or misuse. Claims can be filed through the local distributor or directly on their website.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 8 of 8. The official install manual is the authoritative source — always confirm before acting.
25criticalCall your installerHeat sink is too high
28criticalCall your installerInsulation fault
29criticalCall your installerLeakage protection failure
22warningGrid voltage anomaly
23warningNetwork frequency anomaly
26warningAmbient temperature is too high
34warningParallel Communication Alarm
35warningMeter Reversed
Isuna D10K-SL-S-AU (AS4777-2 2020)
10 kW · 1φ
Isuna D9.9K-SL-AU (AS4777-2 2020)
9.9 kW · 1φ
Isuna D9.9K-SL-S-AU (AS4777-2 2020)
9.9 kW · 1φ
Isuna D8K-SL-AU (AS4777-2 2020)
8 kW · 1φ
Isuna D8K-SL-S-AU (AS4777-2 2020)
8 kW · 1φ
Isuna D12K-SL-AU (AS4777-2 2020)
12 kW · 1φ
Get a quote from an installer from our network that covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.