Hybrid inverter · Deye · CEC approved July 2026
CEC listing: SUN-10K-SG05LP1-AU-AM2-P (AS4777-2 2020)
A 10 kW single-phase hybrid inverter that is battery-ready and listed for battery storage on Synergy's list.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Every figure on file for the Deye SUN-10K-SG05LP1-AU-AM2-P, by section.
| Specification | Value |
|---|---|
| Efficiency | |
| Max efficiency | 97.6% |
| Physical | |
| IP rating | IP65 |
| Rebate eligibility | |
| Listed for battery storage on Synergy's list | Yes |
| Installation requirements | |
| Top clearance | 50 mm |
| Side clearance | 50 mm |
| AC breaker | 100 A |
| Cable gauge | 16 mm² |
| Earthing method | Copper wires |
| DNSP pre-approval | No |
| Estimated install time | 12 hrs |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Listed for battery storage on Synergy's list. Synergy's Supported Solutions List covers inverters approved for control. A battery system needs an inverter with a battery-storage (DER-Storage) listing on this list to be eligible for the WA Battery Scheme. A listing for generation only doesn't count. Other scheme conditions apply.Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Estimate for a full-size array on this inverter
At 5 peak sun hours a day (BOM) with a 15% system derate.
Website
au.deyeinverter.comThe Deye SUN-10K-SG05LP1-AU-AM2-P against the closest-power inverters from other brands.
| Specification | Solplanet ASW010K-SHSolplanet | Solplanet ASW10000-S-ASolplanet | |
|---|---|---|---|
| Rated power? | 9.999 kW | 9.999 kW | 9.999 kW |
| Max efficiency? | 97.6% | Not on file | Not on file |
| MPPT trackers? | Not on file | Not on file | Not on file |
| Phases | Single-phase | Single-phase | Single-phase |
| Type | Hybrid | Hybrid | Solar |
| Battery ready | Yes | Yes | No |
| Warranty | 10 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
The warranty covers defects for 10 years, with a minimum of 80% capacity retained by year 10. Claims can be made via the support channels provided.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 25 of 25. The official install manual is the authoritative source — always confirm before acting.
F01criticalCall your installerDC input polarity reverse fault
F07criticalCall your installerDC_START_Failure
F15criticalCall your installerAC over current fault of software
F16criticalCall your installerAC leakage current fault
F18criticalCall your installerAC over current fault of hardware
F20criticalCall your installerDC over current fault of the hardware
F21criticalCall your installerTz_HV_Overcurr_fault
F23criticalCall your installerTz_GFCI_OC_current is transient over current
F24criticalCall your installerDC insulation failure
F34criticalCall your installerAC Overcurrent fault
F46criticalCall your installerbackup battery fault
F55criticalCall your installerDC busbar voltage is too high
F56criticalCall your installerDC busbar voltage is too low
F58criticalCall your installerBMS communication fault
F63criticalCall your installerARC fault
F64criticalCall your installerHeat sink high temperature failure
F13warningworking mode change
F26warningThe DC busbar is unbalanced
F29warningParallel CAN Bus fault
F41warningParallel system stop
F42warningCall your installerAC line low voltage
F47warningCall your installerAC over frequency
F48warningCall your installerAC lower frequency
F22infoTz_EmergStop_Fault
F62infoDRMs0_stop
AI-W5.1-10P1-AU-B (AS4777-2 2020)
9.999 kW · 1φ
SUN-10K-G02P1-AU-AM2 (AS4777-2 2020)
9.999 kW · 1φ
SUN-10K-SG02LP1-AU-AM3 (AS4777-2 2020)
9.999 kW · 1φ
Al-W5.1-10P1-AU-B (AS4777-2 2020)
10 kW · 1φ
SUN-10.5K-G02P1-AU-AM2 (AS4777-2 2020)
10.5 kW · 1φ
SUN-9K-G02P1-AU-AM2 (AS4777-2 2020)
9 kW · 1φ
Other CEC-approved products from Deye available in Australia.
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.