Solar inverter · I Hot · CEC approved December 2025
A 3.8 kW single-phase solar inverter.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Not on file: we don’t have this figure from the manufacturer’s documents yet, so we leave it blank rather than print a typical value. Ask your installer to confirm it on the quote. Seen it in a document? Tell us
Every figure on file for the I Hot SWHC-4K, by section.
| Specification | Value |
|---|---|
| Physical | |
| IP rating | IP68 |
| Installation requirements | |
| Top clearance | 50 mm |
| Side clearance | 150 mm |
| AC breaker | 63 A |
| Cable gauge | 16 mm² |
| Earthing method | TN-S |
| DNSP pre-approval | No |
| Estimated install time | 6 hrs |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Estimate for a full-size array on this inverter
At 5 peak sun hours a day (BOM) with a 15% system derate.
The I Hot SWHC-4K against the closest-power inverters from other brands.
| Specification | I Hot SWHC-4KI Hot | Fronius Symo 3.7-3-MFronius | Hiconics Eco-energy Drive Technology HEC2-S3.8Hr2Hiconics Eco-energy Drive Technology |
|---|---|---|---|
| Rated power? | 3.75 kW | 3.7 kW | 3.8 kWhighest |
| Max efficiency? | Not on file | Not on file | Not on file |
| MPPT trackers? | Not on file | Not on file | Not on file |
| Phases | Single-phase | Three-phase | Single-phase |
| Type | Solar | Solar | Hybrid |
| Battery ready | No | No | Yes |
| Warranty | 25 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
Enphase offers a 25-year warranty on microinverters, covering product defects but excluding damages from improper installations. To claim, contact customer support for a replacement.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 10 of 10. The official install manual is the authoritative source — always confirm before acting.
F15criticalCall your installerAC Over Current Failure
F16criticalCall your installerGFCI Failure
F20criticalCall your installerDC Over Current Fault
F63criticalCall your installerArc Fault
F82criticalCall your installerBattery Over Voltage Fault
F65warningHeatsink High Temp Fault
F8warningCall your installerGFDI Relay Failure
F81warningCall your installerDC Low Voltage Fault
F1infoDC Inversed Failure
F70infoButton Manual OFF
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.