Loading Solar Battery Perth...
Loading Solar Battery Perth...
Solar inverter · FIMER · PVS series · CEC approved December 2025
CEC listing: PVS-10-TL-SX (AS4777-2 2020)
A 10 kW three-phase solar inverter.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Rated power
How much solar it can turn into usable power at once
Max efficiency
How much of the solar you make reaches the house
Phases
Needs a three-phase supply — check your switchboard
Type
Runs solar only
Every figure on file for the FIMER PVS-10-TL-SX, by section.
| Specification | Value |
|---|---|
| Efficiency | |
| Max efficiency | 98.1% |
| Physical | |
| IP rating | IP65 |
| Installation requirements | |
| Top clearance | 70 mm |
| Side clearance | 30 mm |
| AC breaker | 32 A |
| Cable gauge | 6 mm² |
| Earthing method | TN-S |
| DNSP pre-approval | No |
| Estimated install time | 8 hrs |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Battery compatible
No
Backup capable
No
CEC approved
8 Dec 2025
Approval expiry
10 June 2027
Status
Active
Eligible for rebates
Yes
Years in AU Market
4 years
Australian Office
Yes
CEC-Approved Batteries
0
CEC-Approved Panels
0
Category
Mid-Tier
Typical installed, inverter only
$2,000–$4,000
Prices vary by installer, configuration and site complexity. Get exact quotes from installers you choose.
Compare quotes from installers you choose
Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead — ask your installer to confirm this inverter’s ESM status.
Estimate for a full-size array on this inverter
At 5 peak sun hours a day (BOM) with a 15% system derate.
Australian office
Has local presence
Website
www.fimer.com/auThe FIMER PVS-10-TL-SX against the closest-power inverters from other brands.
| Specification | FIMER PVS-10-TL-SXFIMER | Energizer Force 10.0HS+Energizer | Energizer Force 10.0HT+Energizer |
|---|---|---|---|
| Rated power? | 10 kW | 10 kW | 10 kW |
| Max efficiency? | 98.1%best value | 0.0% | 0.0% |
| MPPT trackers? | Not verified | Not verified | Not verified |
| Phases | Three-phase | Single-phase | Three-phase |
| Type | Solar | Hybrid | Hybrid |
| Battery ready | No | Yes | Yes |
| Warranty | 0 years | Not verified | Not verified |
Specs from the CEC register and datasheet enrichment. Indicative — confirm exact figures with your installer.
Warranty summary
This warranty covers manufacturing defects for 5 years, provided proper installation is followed. Warranty void if exposed to water or installed incorrectly. Claims can be initiated via the FIMER website.
This warranty covers manufacturing defects for 5 years, provided proper installation is followed. Warranty void if exposed to water or installed incorrectly. Claims can be initiated via the FIMER website.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
Part of the FIMER PVS series
Compare every FIMER PVS variant side by side →
PVS-10-TL-SY (AS4777-2 2020)
10 kW · 3φ
PVS-100-TL-POWER MODULE + WB-PVS-100-TL (AS4777-2 2020)
100 kW · 1φ
PVS-100-TL-POWER MODULE + WB-S2-PVS-100-TL (AS4777-2 2020)
100 kW · 1φ
PVS-100-TL-POWER MODULE + WB-SX-PVS-100-TL (AS4777-2 2020)
100 kW · 1φ
PVS-100-TL-POWER MODULE + WB-SX2-PVS-100-TL (AS4777-2 2020)
100 kW · 1φ
PVS-100-TL-POWER MODULE + WB-SY-PVS-100-TL (AS4777-2 2020)
100 kW · 1φ
Get a quote from an installer from our network that covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.