Hybrid inverter · Sunsynk · CEC approved August 2025
CEC listing: SUNSYNK-12K-SG01LP1 (AS4777-2 2020)
A 12 kW single-phase hybrid inverter that is battery-ready.
Sunsynk hybrid inverters carry a broad feature set, and they can also run off-grid. The brand started in South Africa and now sells in Australia.
In Perth, the ECCO series can serve a grid-connected hybrid or an off-grid set-up.
The numbers that matter for a home. The full datasheet is below.
Not on file: we don’t have this figure from the manufacturer’s documents yet, so we leave it blank rather than print a typical value. Ask your installer to confirm it on the quote. Seen it in a document? Tell us
Every figure on file for the Sunsynk SUNSYNK-12K-SG01LP1, by section.
| Specification | Value |
|---|---|
| DC input & MPPT | |
| MPPT trackers | 2 |
| Physical | |
| Weight | 38.5 kg |
| IP rating | IP65 |
| Installation requirements | |
| Top clearance | 500 mm |
| Side clearance | 500 mm |
| AC breaker | 100 A |
| Cable gauge | 21.1 mm² |
| Earthing method | TN-S |
| DNSP pre-approval | No |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Estimate for a full-size array on this inverter
At 5 peak sun hours a day (BOM) with a 15% system derate.
Website
www.sunsynk.comThe Sunsynk SUNSYNK-12K-SG01LP1 against the closest-power inverters from other brands.
| Specification | Sunsynk SUNSYNK-12K-SG01LP1Sunsynk | Energizer Force 12.0HT+Energizer | Afore AF12K-THAfore |
|---|---|---|---|
| Rated power? | 12 kW | 12 kW | 12 kW |
| Max efficiency? | Not on file | Not on file | Not on file |
| MPPT trackers? | 2 | Not on file | Not on file |
| Phases | Single-phase | Three-phase | Three-phase |
| Type | Hybrid | Hybrid | Hybrid |
| Battery ready | Yes | Yes | Yes |
| Warranty | 5 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
The warranty covers defects for 5 years, excluding unqualified installations and tampering. To claim, contact support via email or phone.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 13 of 13. The official install manual is the authoritative source — always confirm before acting.
F08criticalCall your installerGFDI Relay Failure
F24criticalCall your installerDC insulation impedance failure
F48criticalCall your installerDC bus bar voltage too low
F56criticalCall your installerDC bus bar voltage is too low
F18warningAC over current fault
F20warningDC over current fault
F23warningAC leakage current
F35warningCall your installerNo grid
F42warningCall your installerAC line low voltage
F47warningCall your installerAC over frequency
F64warningHeat sink high-temperature failure
F13infoWorking Mode Change
F26infoBus bar imbalance
SUNSYNK-14K-SG01LP1 (AS4777-2 2020)
14 kW · 1φ
SUNSYNK-8K-SG05LP1 (AS4777-2 2020)
8 kW · 1φ
SUNSYNK-16K-SG01LP1 (AS4777-2 2020)
16 kW · 1φ
SUNSYNK-5K-SG04LP1 (AS4777-2 2020)
5 kW · 1φ
SUNSYNK-3.6K-SG04LP1 (AS4777-2 2020)
3.6 kW · 1φ
SUNSYNK-12K-SG01HP3-AU-AM2 (AS4777-2 2020)
12 kW · 3φ
Other CEC-approved products from Sunsynk available in Australia.
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.