Hybrid inverter · Noark Electrics · CEC approved January 2024
CEC listing: Ex9N-DH-8KS-AU (AS4777-2 2020)
An 8 kW single-phase hybrid inverter that is battery-ready and listed for battery storage on Synergy's list.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Not on file: we don’t have this figure from the manufacturer’s documents yet, so we leave it blank rather than print a typical value. Ask your installer to confirm it on the quote. Seen it in a document? Tell us
Every figure on file for the Noark Electrics Ex9N-DH-8KS-AU, by section.
| Specification | Value |
|---|---|
| Physical | |
| IP rating | IP65 |
| Rebate eligibility | |
| Listed for battery storage on Synergy's list | Yes |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Listed for battery storage on Synergy's list. Synergy's Supported Solutions List covers inverters approved for control. A battery system needs an inverter with a battery-storage (DER-Storage) listing on this list to be eligible for the WA Battery Scheme. A listing for generation only doesn't count. Other scheme conditions apply.Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Estimate for a full-size array on this inverter
At 5 peak sun hours a day (BOM) with a 15% system derate.
The Noark Electrics Ex9N-DH-8KS-AU against the closest-power inverters from other brands.
| Specification | Noark Electrics Ex9N-DH-8KS-AUNoark Electrics | Energizer Force 8.0HS+Energizer | Energizer Force 8.0HT+Energizer |
|---|---|---|---|
| Rated power? | 8 kW | 8 kW | 8 kW |
| Max efficiency? | Not on file | Not on file | Not on file |
| MPPT trackers? | Not on file | Not on file | Not on file |
| Phases | Single-phase | Single-phase | Three-phase |
| Type | Hybrid | Hybrid | Hybrid |
| Battery ready | Yes | Yes | Yes |
| Warranty | 10 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
This warranty covers the inverter for 10 years against defects. It excludes damage from improper installation or modifications. To make a claim, contact customer support with your warranty details.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 25 of 25. The official install manual is the authoritative source — always confirm before acting.
F01criticalCall your installerDC input polarity reverse fault
F07criticalCall your installerDC_START_Failure
F16criticalCall your installerAC leakage current fault
F20criticalCall your installerDC over current fault of the hardware
F21criticalCall your installerBUS over current
F23criticalCall your installerLeakage current fault
F34criticalCall your installerBackup load connected exceeds limits
F41criticalCall your installerHybrid inverter work status issue
F42criticalCall your installerGrid AC voltage connection issue
F46criticalCall your installerBackup battery fault
F55criticalCall your installerDC busbar voltage is too high
F58criticalCall your installerBMS communication fault
F64criticalCall your installerHeat sink high temperature failure
F15warningCall your installerAC over current fault of software
F18warningCall your installerAC over current fault of hardware
F24warningCall your installerPV isolation resistance is too low
F47warningCall your installerAC over frequency
F48warningCall your installerAC lower frequency
F56warningCall your installerDC busbar voltage is too low
F63warningCall your installerARC fault (specific to US market)
F13infoWorking mode change
F22infoRemotely shutdown
F26infoCall your installerInconsistent load power across phases
F29infoParallel communication issue
F62infoDRM function malfunction
Ex9N-DH-7.6KS-AU (AS4777-2 2020)
7.6 kW · 1φ
Ex9N-DG-6KS-AU (AS4777-2 2020)
6 kW · 1φ
Ex9N-DH-6KS-AU (AS4777-2 2020)
6 kW · 1φ
Ex9N-DG-5KS-AU (AS4777-2 2020)
5 kW · 1φ
Ex9N-DH-5KS-AU (AS4777-2 2020)
5 kW · 1φ
Ex9N-DG-4.6KS-AU (AS4777-2 2020)
4.6 kW · 1φ
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.