Solar inverter · Ningbo Sunways Technologies · CEC approved September 2026
CEC listing: STS-5KTL-NS (AS4777-2 2020)
A 5 kW single-phase solar inverter.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Every figure on file for the Ningbo Sunways Technologies STS-5KTL-NS, by section.
| Specification | Value |
|---|---|
| Efficiency | |
| Max efficiency | 98.1% |
| European efficiency | 97.5% |
| Physical | |
| IP rating | IP65 |
| Installation requirements | |
| Top clearance | 100 mm |
| Side clearance | 100 mm |
| AC breaker | 40 A |
| Cable gauge | 6 mm² |
| Earthing method | TN-S |
| DNSP pre-approval | Yes |
| Estimated install time | 8 hrs |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Estimate for a full-size array on this inverter
At 5 peak sun hours a day (BOM) with a 15% system derate.
The Ningbo Sunways Technologies STS-5KTL-NS against the closest-power inverters from other brands.
| Specification | Ningbo Sunways Technologies STS-5KTL-NSNingbo Sunways Technologies | Energizer FORCE 5.0HSEnergizer | Energizer Force 5.0HT+Energizer |
|---|---|---|---|
| Rated power? | 5 kW | 5 kW | 5 kW |
| Max efficiency? | 98.1% | Not on file | Not on file |
| MPPT trackers? | Not on file | Not on file | Not on file |
| Phases | Single-phase | Single-phase | Three-phase |
| Type | Solar | Hybrid | Hybrid |
| Battery ready | No | Yes | Yes |
| Warranty | 10 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
This inverter has a 10-year warranty covering defects in materials and workmanship. Warranty voids if misused or modified. To claim, contact customer support.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 16 of 16. The official install manual is the authoritative source — always confirm before acting.
AC Transducer FaultcriticalCall your installerFault in the AC transducer.
Bus Voltage FaultcriticalCall your installerBus voltage is over the allowed limit.
DCI FaultcriticalCall your installerDirect Current Input fault.
GFCI Device FaultcriticalCall your installerFault detected in the GFCI device.
GFCI FaultcriticalCall your installerGround Fault circuit interrupt fault detected.
Grid Frequency FaultcriticalCall your installerThe grid frequency is outside allowed parameters.
Grid Voltage FaultcriticalCall your installerThe grid voltage is outside allowed parameters.
Inverter Over TemperaturecriticalCall your installerInverter is too hot.
ISO Over LimitationcriticalCall your installerIsolated condition exceeds limits.
PV Over VoltagecriticalCall your installerPhotovoltaic input voltage is too high.
Relay Check FailcriticalCall your installerRelay operation check has failed.
E2 FaultwarningCall your installerError code indicating a system error.
Flash FaultwarningCall your installerError related to the inverter's firmware.
Mains LostwarningNo electricity from the mains supply detected.
SCI FaultwarningCall your installerSerial Communication Interface fault.
SPI FaultwarningCall your installerSerial Peripheral Interface fault.
STS-5KTL (AS4777-2 2020)
5 kW · 1φ
STS-5KTL-P (AS4777-2 2020)
5 kW · 1φ
STH-5KTL-HS (AS4777-2 2020)
4.99 kW · 1φ
STH-4.6KTL-HS (AS4777-2 2020)
4.6 kW · 1φ
STS-4.6KTL-P (AS4777-2 2020)
4.6 kW · 1φ
STH-4.2KTL-HS (AS4777-2 2020)
4.2 kW · 1φ
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.