Hybrid inverter · Deye · CEC approved September 2026
CEC listing: SUN-50K-SG01HP3-AU-BM4 (AS4777-2 2020)
A 50 kW three-phase hybrid inverter that is battery-ready and listed for battery storage on Synergy's list.
Commercial-scale inverter
At 50 kW, this is built for businesses and large sites. A typical home inverter is 5–10 kW.
Browse home-size inverters →Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Every figure on file for the Deye SUN-50K-SG01HP3-AU-BM4, by section.
| Specification | Value |
|---|---|
| Efficiency | |
| Max efficiency | 97.6% |
| Physical | |
| IP rating | IP65 |
| Operating temperature | -20°C to 55°C |
| Rebate eligibility | |
| Listed for battery storage on Synergy's list | Yes |
| Installation requirements | |
| Top clearance | 10 mm |
| Side clearance | 10 mm |
| AC breaker | 125 A |
| Cable gauge | 4 mm² |
| Earthing method | TN-S |
| DNSP pre-approval | Yes |
| Estimated install time | 8 hrs |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Listed for battery storage on Synergy's list. Synergy's Supported Solutions List covers inverters approved for control. A battery system needs an inverter with a battery-storage (DER-Storage) listing on this list to be eligible for the WA Battery Scheme. A listing for generation only doesn't count. Other scheme conditions apply.Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Website
au.deyeinverter.comThe Deye SUN-50K-SG01HP3-AU-BM4 against the closest-power inverters from other brands.
| Specification | Solplanet ASW50K-LT-G3Solplanet | Alpha ESS M50-INV-AUAlpha ESS | |
|---|---|---|---|
| Rated power? | 50 kW | 50 kW | 50 kW |
| Max efficiency? | 97.6% | Not on file | Not on file |
| MPPT trackers? | Not on file | Not on file | Not on file |
| Phases | Three-phase | Three-phase | Three-phase |
| Type | Hybrid | Solar | Hybrid |
| Battery ready | Yes | No | Yes |
| Warranty | 10 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
This warranty covers the product for 10 years against defects. It excludes non-accredited installations. Claims can be made by contacting support via phone or email.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 7 of 7. The official install manual is the authoritative source — always confirm before acting.
BMS FaultcriticalCall your installerBMS fault indicates issues with the battery management system.
Electrochemical Cell FaultcriticalCall your installerElectrochemical cell fault indicates low or unbalanced cell voltage.
Charge High Temperature ProtectionwarningCall your installerProtection activated due to excessive cell temperature during charging.
Charge Low Temperature ProtectionwarningCall your installerProtection activated due to excessively low cell temperatures during charging.
Discharge Low Temperature ProtectionwarningCall your installerProtection activated due to excessively low cell temperatures during discharge.
Overvoltage ProtectionwarningCall your installerOvervoltage protection is triggered when the battery voltage exceeds normal values.
Under Voltage ProtectionwarningCall your installerUnder voltage protection indicates battery voltage is too low.
SUN-40K-SG01HP3-AU-BM4 (AS4777-2 2020)
40 kW · 3φ
SUN-60K-SG02HP3-AU-EM6 (AS4777-2 2020)
60 kW · 3φ
SUN-35K-SG01HP3-AU-BM3 (AS4777-2 2020)
35 kW · 3φ
SUN-30K-SG01HP3-AU-BM3 (AS4777-2 2020)
30 kW · 3φ
SUN-70K-SG02HP3-AU-EM6 (AS4777-2 2020)
70 kW · 3φ
SUN-29.9K-SG01HP3-AU-BM3 (AS4777-2 2020)
29.9 kW · 3φ
Other CEC-approved products from Deye available in Australia.
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.