Hybrid inverter · Must · CEC approved April 2026
CEC listing: PH11-12KL3-EU (AS4777-2 2020)
A 12 kW three-phase hybrid inverter that is battery-ready.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Not on file: we don’t have this figure from the manufacturer’s documents yet, so we leave it blank rather than print a typical value. Ask your installer to confirm it on the quote. Seen it in a document? Tell us
Every figure on file for the Must PH11-12KL3-EU, by section.
| Specification | Value |
|---|---|
| Physical | |
| IP rating | IP66 |
| Installation requirements | |
| Top clearance | 500 mm |
| Side clearance | 500 mm |
| AC breaker | 63 A |
| Cable gauge | 10 mm² |
| Earthing method | TN-S |
| DNSP pre-approval | No |
| Estimated install time | 8 hrs |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Estimate for a full-size array on this inverter
At 5 peak sun hours a day (BOM) with a 15% system derate.
The Must PH11-12KL3-EU against the closest-power inverters from other brands.
| Specification | Energizer Force 12.0HT+Energizer | Afore AF12K-THAfore | |
|---|---|---|---|
| Rated power? | 12 kW | 12 kW | 12 kW |
| Max efficiency? | Not on file | Not on file | Not on file |
| MPPT trackers? | Not on file | Not on file | Not on file |
| Phases | Three-phase | Three-phase | Three-phase |
| Type | Hybrid | Hybrid | Hybrid |
| Battery ready | Yes | Yes | Yes |
| Warranty | 5 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
This inverter comes with a 5-year warranty covering defects from accredited installations. Coverage is void if modified or tampered with.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 16 of 16. The official install manual is the authoritative source — always confirm before acting.
F01criticalCall your installerDC input polarity reverse fault
F07criticalCall your installerDC_START_Failure
F16criticalCall your installerAC leakage current fault
F18criticalCall your installerAC over current fault of hardware
F20criticalCall your installerDC over current fault of the hardware
F21criticalCall your installerBUS over current
F23criticalCall your installerGFCI_OC_current is transient over current
F24criticalCall your installerDC insulation failure
F46criticalCall your installerBackup battery fault
F56criticalCall your installerDC busbar voltage is too low
F64criticalCall your installerHeat sink high temperature failure
F13warningWorking mode change
F15warningAC over current fault of software
F47warningCall your installerAC over frequency
F48warningCall your installerAC lower frequency
F22infoRemotely shutdown
PH11-10KL3-EU (AS4777-2 2020)
10 kW · 3φ
PH11-8KL3-EU (AS4777-2 2020)
8 kW · 3φ
PH11-6.5KL3 EU (AS4777-2 2020)
6.5 kW · 3φ
PH11-5KL3-EU (AS4777-2 2020)
5 kW · 3φ
Other CEC-approved products from Must available in Australia.
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.