Solar inverter · Morningstar · CEC approved June 2024
A single-phase solar inverter.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Not on file: we don’t have these figures from the manufacturer’s documents yet, so we leave them blank rather than print typical values. Ask your installer to confirm them on the quote. Seen it in a document? Tell us
Every figure on file for the Morningstar GS-MPPT-100M-200V, by section.
| Specification | Value |
|---|---|
| Physical | |
| Operating temperature | -30°C to 45°C |
| Installation requirements | |
| Top clearance | 150 mm |
| Side clearance | 75 mm |
| AC breaker | 80 A |
| Cable gauge | 53.5 mm² |
| Earthing method | Negative Ground |
| DNSP pre-approval | No |
| Estimated install time | 8 hrs |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
This warranty covers defects in materials and workmanship for five years. Exclusions include damage from improper use and exceeding ratings. For claims, contact an authorized dealer for assistance.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 11 of 11. The official install manual is the authoritative source — always confirm before acting.
Charging Status High Heatsink TemperaturecriticalCall your installerHeatsink temperature is too high.
Firmware Update FailurecriticalCall your installerFirmware update was not successful.
Heatsink Temperature Sensor Open / ShortedcriticalCall your installerThe heatsink temperature sensor is damaged.
High Battery Voltage Disconnect (HVD)criticalCall your installerBattery voltage is above normal operating limits.
High Input Voltage Current LimitcriticalCall your installerThe solar input voltage is too high.
High Temperature Current LimitcriticalCall your installerHeatsink temperature exceeds safe limits.
Battery Sense Out of Range / DisconnectedwarningBattery sense wire is disconnected. Inspect the battery sense connections.
Current LimitwarningThe array power exceeds the rating of the controller.
Load Short CircuitwarningDetected a short circuit in load wiring.
RTS OpenwarningRemote Temperature Sensor not connected.
UncalibratedwarningCall your installerThe controller was not factory calibrated.
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.