Hybrid inverter · SAJ · CEC approved September 2026
CEC listing: EK90 HS5-8K-S3 (AS4777-2 2020)
An 8 kW single-phase hybrid inverter that is battery-ready and listed for battery storage on Synergy's list.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Every figure on file for the SAJ EK90 HS5-8K-S3, by section.
| Specification | Value |
|---|---|
| Efficiency | |
| Max efficiency | 98% |
| DC input & MPPT | |
| MPPT trackers | 1 |
| Physical | |
| IP rating | IP66 |
| Rebate eligibility | |
| Listed for battery storage on Synergy's list | Yes |
| Installation requirements | |
| Top clearance | 0 mm |
| Side clearance | 0 mm |
| AC breaker | 63 A |
| DNSP pre-approval | Yes |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Listed for battery storage on Synergy's list. Synergy's Supported Solutions List covers inverters approved for control. A battery system needs an inverter with a battery-storage (DER-Storage) listing on this list to be eligible for the WA Battery Scheme. A listing for generation only doesn't count. Other scheme conditions apply.Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Estimate for a full-size array on this inverter
At 5 peak sun hours a day (BOM) with a 15% system derate.
Website
www.saj-electric.comThe SAJ EK90 HS5-8K-S3 against the closest-power inverters from other brands.
| Specification | Energizer Force 8.0HS+Energizer | Energizer Force 8.0HT+Energizer | |
|---|---|---|---|
| Rated power? | 8 kW | 8 kW | 8 kW |
| Max efficiency? | 98.0% | Not on file | Not on file |
| MPPT trackers? | 1 | Not on file | Not on file |
| Phases | Single-phase | Single-phase | Three-phase |
| Type | Hybrid | Hybrid | Hybrid |
| Battery ready | Yes | Yes | Yes |
| Warranty | 10 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
The warranty covers defects for 10 years, with a 90% capacity retention at year 10. Warranty voids include non-accredited installation. Claims can be made via the support website.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 19 of 19. The official install manual is the authoritative source — always confirm before acting.
1criticalCall your installerMaster Relay Error
17criticalCall your installerMaster Output_Shorter
2criticalCall your installerMaster EEPROM Error
3criticalCall your installerMaster Temperature High Error
10warningCall your installerMaster Phase1 Voltage Low
11warningCall your installerMaster Phase2 Voltage High
12warningCall your installerMaster Phase2 Voltage Low
13warningCall your installerMaster Phase3 Voltage High
14warningCall your installerMaster Phase3 Voltage Low
15warningCall your installerMaster Voltage 10Min High
16warningCall your installerMaster OffGrid Voltage Low
18warningCall your installerMaster Grid Frequency High
19warningCall your installerMaster Grid Frequency Low
4warningMaster Temperature Low Error
5warningCall your installerMaster Lost Communication M<->S
6warningCall your installerMaster GFCI Device Error
7warningCall your installerMaster DCI Device Error
8warningCall your installerMaster Current Sensor Error
9warningCall your installerMaster Phase1 Voltage High
EK70 HS5-8K-S3 (AS4777-2 2020)
8 kW · 1φ
H2-8K-S3 (AS4777-2 2020)
8 kW · 1φ
R5-8K-S2-15 (AS4777-2 2020)
8 kW · 1φ
R5-8K-S2 (AS4777-2 2020)
8 kW · 1φ
R5-8K-T2-15 (AS4777-2 2020)
8 kW · 1φ
R5-8K-T2 (AS4777-2 2020)
8 kW · 1φ
Other CEC-approved products from SAJ available in Australia.
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.