Hybrid inverter · GoodWe · CEC approved March 2026
CEC listing: GW6000-ES-20 (AS4777-2 2020)
A 6 kW single-phase hybrid inverter that is battery-ready and listed for battery storage on Synergy's list.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Every figure on file for the GoodWe GW6000-ES-20, by section.
| Specification | Value |
|---|---|
| Efficiency | |
| Max efficiency | 97.6% |
| European efficiency | 96.7% |
| DC input & MPPT | |
| MPPT trackers | 2 |
| Physical | |
| IP rating | IP65 |
| Rebate eligibility | |
| Listed for battery storage on Synergy's list | Yes |
| Installation requirements | |
| Top clearance | 300 mm |
| Side clearance | 200 mm |
| AC breaker | 40 A |
| Cable gauge | 6 mm² |
| Earthing method | TN-S |
| DNSP pre-approval | No |
| Estimated install time | 5 hrs |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Listed for battery storage on Synergy's list. Synergy's Supported Solutions List covers inverters approved for control. A battery system needs an inverter with a battery-storage (DER-Storage) listing on this list to be eligible for the WA Battery Scheme. A listing for generation only doesn't count. Other scheme conditions apply.Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Estimate for a full-size array on this inverter
At 5 peak sun hours a day (BOM) with a 15% system derate.
Australian office
Has local presence
Website
www.goodwe.com.auThe GoodWe GW6000-ES-20 against the closest-power inverters from other brands.
| Specification | GoodWe GW6000-ES-20GoodWe | Energizer FORCE 6.0HSEnergizer | Energizer Force 6.0HT+Energizer |
|---|---|---|---|
| Rated power? | 6 kW | 6 kW | 6 kW |
| Max efficiency? | 97.6% | Not on file | Not on file |
| MPPT trackers? | 2 | Not on file | Not on file |
| Phases | Single-phase | Single-phase | Three-phase |
| Type | Hybrid | Hybrid | Hybrid |
| Battery ready | Yes | Yes | Yes |
| Warranty | 10 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
This warranty covers manufacturing defects for 10 years. Modifications void the warranty. To claim, visit https://en.goodwe.com/warranty.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 10 of 10. The official install manual is the authoritative source — always confirm before acting.
Abnormal GroundcriticalCall your installerPE cable not connected properly or L & N cables reversed.
DC Arc FaultcriticalCall your installerThe DC terminal is not securely connected or the cable is broken.
Large DC of AC current L1criticalCall your installerThe DC component of output current exceeds safe limits.
Low Insulation Res. (Earth Fault Alarm)criticalCall your installerInsulation resistance to ground is too low.
Anti-islandingwarningCall your installerThe utility grid is disconnected due to safety regulations.
Grid OverfrequencywarningCall your installerThe actual grid frequency exceeds local grid standard limits.
Grid OvervoltagewarningCall your installerThe grid voltage exceeds permissible limits.
Grid Rapid OvervoltagewarningCall your installerThe grid voltage is abnormally high.
Grid UndervoltagewarningCall your installerThe grid voltage is lower than permissible limits.
Utility LosswarningUtility grid power fails or AC cable is disconnected.
GEP6.0-1-30 (AS4777-2 2020)
6 kW · 1φ
GW6000-BH (AS4777-2 2020)
6 kW · 1φ
GW6000-DNS-30 (AS4777-2 2020)
6 kW · 1φ
GW6000-EH (AS4777-2 2020)
6 kW · 1φ
GW6000-MS-30 (AS4777-2 2020)
6 kW · 1φ
GW6000-MS (AS4777-2 2020)
6 kW · 1φ
Other CEC-approved products from GoodWe available in Australia.
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.