Hybrid inverter · GoodWe · CEC approved August 2025
CEC listing: GW40K-ET-10 (AS4777-2 2020)
A 40 kW three-phase hybrid inverter that is battery-ready.
Commercial-scale inverter
At 40 kW, this is built for businesses and large sites. A typical home inverter is 5–10 kW.
Browse home-size inverters →Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Every figure on file for the GoodWe GW40K-ET-10, by section.
| Specification | Value |
|---|---|
| Efficiency | |
| Max efficiency | 97.6% |
| European efficiency | 96.8% |
| Physical | |
| IP rating | IP66 |
| Installation requirements | |
| Top clearance | 0 mm |
| Side clearance | 0 mm |
| AC breaker | 25 A |
| Cable gauge | 4 mm² |
| Earthing method | TN-S |
| DNSP pre-approval | No |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Australian office
Has local presence
Website
www.goodwe.com.auThe GoodWe GW40K-ET-10 against the closest-power inverters from other brands.
| Specification | GoodWe GW40K-ET-10GoodWe | Solplanet ASW40K-LT-G3Solplanet | Solis S5-GC40K-AUSolis |
|---|---|---|---|
| Rated power? | 40 kW | 40 kW | 40 kW |
| Max efficiency? | 97.6% | Not on file | Not on file |
| MPPT trackers? | Not on file | Not on file | Not on file |
| Phases | Three-phase | Three-phase | Three-phase |
| Type | Hybrid | Solar | Solar |
| Battery ready | Yes | No | No |
| Warranty | 10 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
GOODWE offers up to 10 years warranty on inverters; it covers defects but excludes issues from improper installation. Claims can be made through your distributor or installer.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 14 of 14. The official install manual is the authoritative source — always confirm before acting.
FAC FailurecriticalCall your installerGrid frequency is not within permissible range
Ground FailurecriticalCall your installerGround leakage current is too high
Isolation FailurecriticalCall your installerGround insulation impedance of PV string is too low
Over TemperaturecriticalCall your installerTemperature inside of the inverter is too high
PV/BAT OvervoltagecriticalCall your installerThe PV or BAT voltage is too high
Relay Check FailurecriticalCall your installerSelf-checking of relay failure
Utility LosscriticalCall your installerPublic grid power is not available (power lost or on-grid connection fails)
Utility Phase FailurecriticalCall your installerThe sequence of the on-grid wire is incorrect
VAC FailurecriticalCall your installerGrid voltage is not within permissible range
Back-Up Over LoadwarningBack-up side is overloaded
DC Bus HighwarningCall your installerBUS voltage is over-high
DC Injection HighwarningCall your installerDC component in AC output is too high
EEPROM R/W FailurewarningCall your installerEEPROM read/write failure
SPI FailurewarningCall your installerInternal communication failure
GW36K-MT (AS4777-2 2020)
36 kW · 3φ
GW50K-ET-10 (AS4777-2 2020)
50 kW · 3φ
GW50KS-MT (AS4777-2 2020)
50 kW · 3φ
GW29.999K-BTA-G20 (AS4777-2 2020)
29.999 kW · 3φ
GW29.999K-ETA-G20 (AS4777-2 2020)
29.999 kW · 3φ
GW29K9-SDT-AU30 (AS4777-2 2020)
29.99 kW · 3φ
Other CEC-approved products from GoodWe available in Australia.
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.