Hybrid inverter · FoxESS · CEC approved November 2026
CEC listing: PQ3-10.0-L-M_EQ5500-S_4S (AS4777-2 2020)
A 10 kW three-phase hybrid inverter that is battery-ready.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Not on file: we don’t have this figure from the manufacturer’s documents yet, so we leave it blank rather than print a typical value. Ask your installer to confirm it on the quote. Seen it in a document? Tell us
Every figure on file for the FoxESS PQ3-10.0-L-M_EQ5500-S_4S, by section.
| Specification | Value |
|---|---|
| Installation requirements | |
| Top clearance | 300 mm |
| Side clearance | 300 mm |
| AC breaker | 40 A |
| Cable gauge | 6 mm² |
| Earthing method | TNS |
| DNSP pre-approval | Yes |
| Estimated install time | 5 hrs |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Estimate for a full-size array on this inverter
At 5 peak sun hours a day (BOM) with a 15% system derate.
Australian office
Has local presence
Website
au.fox-ess.comThe FoxESS PQ3-10.0-L-M_EQ5500-S_4S against the closest-power inverters from other brands.
| Specification | Solplanet ASW010K-SHSolplanet | Solplanet ASW10000-S-ASolplanet | |
|---|---|---|---|
| Rated power? | 9.999 kW | 9.999 kW | 9.999 kW |
| Max efficiency? | Not on file | Not on file | Not on file |
| MPPT trackers? | Not on file | Not on file | Not on file |
| Phases | Three-phase | Single-phase | Single-phase |
| Type | Hybrid | Hybrid | Solar |
| Battery ready | Yes | Yes | No |
| Warranty | 10 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
This warranty covers defects in materials and workmanship for 10 years. It excludes damage from non-accredited installation. To make a claim, contact an authorized installer.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 19 of 19. The official install manual is the authoritative source — always confirm before acting.
10min Volt FaultcriticalCall your installerGrid voltage has been out of range for the last 10 minutes.
DCI FaultcriticalCall your installerDC component is outside the limit in output current.
Grid Freq FaultcriticalCall your installerThe grid frequency is out of the specified range.
Grid Lost FaultcriticalCall your installerThe grid connection has been lost.
Grid Volt FaultcriticalCall your installerThe grid voltage is out of the specified range.
Ground FaultcriticalCall your installerGround connection has failed.
HW Inv Cur FaultcriticalCall your installerHigh output current detected by the hardware.
Iso FaultcriticalCall your installerIsolation has failed.
Res Cur FaultcriticalCall your installerHigh residual current detected.
SW Bus Vol FaultcriticalCall your installerBus voltage is out of the specified range as detected by software.
SW Inv Cur FaultcriticalCall your installerHigh output current detected by the software.
SW Pv Cur FaultcriticalCall your installerHigh PV input current detected by software.
BACKUP Over LoadwarningCall your installerOverload detected in backup mode.
Bat Power LowwarningCall your installerBattery power is low.
Bat Volt FaultwarningCall your installerBattery voltage fault detected.
Over Load FaultwarningCall your installerOverload detected in on-grid mode.
Pv Volt FaultwarningCall your installerPV voltage is out of the acceptable range.
SW Bat Cur FaultwarningCall your installerHigh battery current detected by software.
Temp FaultwarningCall your installerInverter temperature is too high.
PQ3-10.0-L-M_EQ5500-S_2S (AS4777-2 2020)
9.999 kW · 3φ
PQ3-10.0-L-M_EQ5500-S_3S (AS4777-2 2020)
9.999 kW · 3φ
PQ3-10.0-L-M_EQ5500-S_5S (AS4777-2 2020)
9.999 kW · 3φ
PQ3-10.0-L-M_EQ5500-S_6S (AS4777-2 2020)
9.999 kW · 3φ
PQ3-10.0-L-M_EQ5500-S_7S (AS4777-2 2020)
9.999 kW · 3φ
PQ3-10.0-L-M_EQ5500-S_8S (AS4777-2 2020)
9.999 kW · 3φ
Other CEC-approved products from FoxESS available in Australia.
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.