Hybrid inverter · Hinen · CEC approved February 2024
CEC listing: H3600-EU (AS4777-2 2020)
A 3.7 kW single-phase hybrid inverter that is battery-ready and listed for battery storage on Synergy's list.
Read from the figures on this page. No review written yet.
The numbers that matter for a home. The full datasheet is below.
Not on file: we don’t have this figure from the manufacturer’s documents yet, so we leave it blank rather than print a typical value. Ask your installer to confirm it on the quote. Seen it in a document? Tell us
Every figure on file for the Hinen H3600-EU, by section.
| Specification | Value |
|---|---|
| DC input & MPPT | |
| MPPT trackers | 2 |
| Physical | |
| IP rating | IP65 |
| Rebate eligibility | |
| Listed for battery storage on Synergy's list | Yes |
| Installation requirements | |
| Top clearance | 300 mm |
| Side clearance | 200 mm |
| AC breaker | 40 A |
| Cable gauge | 6 mm² |
| Earthing method | TN-S |
| DNSP pre-approval | Yes |
| Estimated install time | 5 hrs |
Parsed from the manufacturer datasheet, install manual, and warranty document. Confirm against the linked PDFs before relying on a value for a quote or installation.
Get a quote from an installer sourced from the WA (Synergy/Plenti) approved list
Listed for battery storage on Synergy's list. Synergy's Supported Solutions List covers inverters approved for control. A battery system needs an inverter with a battery-storage (DER-Storage) listing on this list to be eligible for the WA Battery Scheme. A listing for generation only doesn't count. Other scheme conditions apply.Western Power approval is required for every grid-connected install. Under Emergency Solar Management, a new system must be remotely manageable, or take an export limit instead. Ask your installer to confirm this inverter’s ESM status.
Estimate for a full-size array on this inverter
At 5 peak sun hours a day (BOM) with a 15% system derate.
Website
www.hinen.comThe Hinen H3600-EU against the closest-power inverters from other brands.
| Specification | Hinen H3600-EUHinen | Energizer FORCE 3.7HSEnergizer | Solplanet ASW3680-SSolplanet |
|---|---|---|---|
| Rated power? | 3.68 kW | 3.68 kW | 3.68 kW |
| Max efficiency? | Not on file | Not on file | Not on file |
| MPPT trackers? | 2 | Not on file | Not on file |
| Phases | Single-phase | Single-phase | Single-phase |
| Type | Hybrid | Hybrid | Solar |
| Battery ready | Yes | Yes | No |
| Warranty | 10 years | Not on file | Not on file |
Specs from the CEC register and datasheet enrichment. Indicative: confirm exact figures with your installer.
Coverage includes defects for 5 years. Non-compliance with installation guidelines voids the warranty. Claim via support email.
AI-summarised from the manufacturer warranty document. Always confirm against the linked PDF before relying on it for a claim.
From the install manual
Showing 17 of 17. The official install manual is the authoritative source — always confirm before acting.
108criticalCall your installerNTC Temperature too high
109criticalCall your installerBus voltage abnormal
110criticalCall your installerCommunication fault
200criticalCall your installerNo AC Connection
201criticalCall your installerAC V Outrange
202criticalCall your installerAC F Outrange
205criticalCall your installerCT LN Reversed
300criticalCall your installerEPS OP Short Fault
302criticalCall your installerOff-grid output voltage is too low
303criticalCall your installerOff-grid output voltage is too High
401criticalCall your installerThe DC input voltage is exceeding the maximum tolerable value
500criticalCall your installerBMS Communication fault
502criticalCall your installerBattery voltage low
503criticalCall your installerBattery Voltage High
504criticalCall your installerBattery temperature out of specified range for charge or discharge
505criticalCall your installerBattery terminals reversed
506criticalCall your installerBattery terminal open (only for lithium battery)
A3600S (AS4777-2 2020)
3.6 kW · 1φ
A3600S-E (AS4777-2 2020)
3.6 kW · 1φ
AC3600S (AS4777-2 2020)
3.6 kW · 1φ
AC3600S-E (AS4777-2 2020)
3.6 kW · 1φ
H4000-EU (AS4777-2 2020)
4 kW · 1φ
H3000-EU (AS4777-2 2020)
3 kW · 1φ
Other CEC-approved products from Hinen available in Australia.
Get a quote from a member installer who covers your area. You choose whether to act on it. No obligation.
About this data
All inverter specifications are sourced from the CEC Approved Products Register. Specifications are provided as published by the CEC and may differ from manufacturer datasheets. Verify current specifications with the manufacturer or your installer before purchasing. Not all listed models may be currently available in Western Australia.